Automotive Technology classes are typically offered ONLY during the 8 week terms (A/B)
This Sample Program Pathway is designed to provide an example of course selections in a term by term sequence. Please see an Academic Advisor for a plan specific to your academic needs.
Description: Work assignment practices that are necessary for beginning automotive service technicians. Hand tool usage, correcting wind noise and water leaks, oil changes, tire rotations and balancing, new vehicle prep, used car inspection. Eye protection and hand tools are required.
Notes: A-Term
Description: Engine operation, nomenclature, measurements and tolerances, including service and overhaul procedures. Cooling, lubrication and valve train systems are discussed. Basic engine machining practices are covered. Basic hand tools are required for the course.
Notes: B-Term
Description: Comprehension of Ohm’s law, basic electrical circuits, digital meter usage, batteries, starting and charging system operation. Diagnosis of wire harness repair procedures and service. One classroom, six lab hours per week.
Notes: B-Term
Term hours subtotal:
9
Description: Theory and operation of clutch, manual transmission and transaxle, rear axle, limited slip differential, drive shaft, universal joint, four- wheel drive/all-wheel drive, diagnosis and repair. Basic hand tools required. One classroom, six lab hours per week.
Notes: A-Term
Description: Theory and operation of hydraulic braking systems, drum brake, disc brake and power assist diagnosis and service. One classroom, six lab hours per week.
Notes: A-Term
Description: Theory and operation of automotive heating and air-conditioning systems. Includes lab activity in diagnosis, service and repair procedures. Basic hand tools required. One classroom, six lab hours per week.
Notes: B-Term
Term hours subtotal:
9
Description: Operation and service of fuel injection systems. Testing and evaluation of emission controls, on-board diagnostic systems and engine condition. Basic hand tools required. Two classroom, six lab hours per week.
Notes: A-Term
Prerequisites: AUT 1114
Description: Theory and operation of automotive transmissions and transaxle systems. Lab experience in the overhaul and service of automatic transmissions and transaxles including mechanical, hydraulic and electronic systems diagnostics and testing.
Notes: A-Term
Description: Advanced diagnosis and repair of computer controlled fuel delivery, fuel injection, ignition, emission systems and proper use of advanced engine performance diagnostic equipment. Basic handtools required.
Notes: B-Term
Prerequisites: AUT 1115
Term hours subtotal:
12
Description: Advanced electrical/electronic system diagnosis and troubleshooting of starting and charging systems, lighting systems, dashboard instrumentation, body control and accessory circuits. SRS system operation, testing and diagnosis. AC and DC motor theory, operation and diagnosis. Schematic utilization. Diagnose serial data bus communication and module systems. Two classroom, six lab hours per week.
Notes: B-Term
Prerequisites: AUT 1114
Description: Steering system diagnosis and service including front and rear suspension components, wheel and tire and front and rear wheel alignment. Basic hand tools are required. One classroom, six lab hours per week.
Notes: A-Term
Term hours subtotal:
7